Bosch SE3000 Series, Техническое справочное руководство

Страница: 191 / 256

Security Escort System menus and dialogs | en 191
Robert Bosch (SEA) Pte Ltd Technical Reference Manual 2018.03 | SE3v1.0 | DOC
Element Usage/Description
[I'M OK Check]
[I'M OK Release
Control] These buttons are used to diagnose and correct communications
problems between the Central Console and the SE coordinator.
The system software requires that each SE coordinator send a
message to the Central Console periodically if no other
communications have taken place. These messages are called “I’m
OK” messages. If for some reason the communications link
between the Central Console and the SE coordinator fails, the SE
coordinator recognizes the fact when its “I’m OK” transmissions
are not acknowledged by the Central Console. When the SE
coordinator has retried transmitting an “I’m OK” message or any
other message 6 times without acknowledgment, it assumes
control of the outputs (LEDs, horns, strobes, and sirens) on
devices connected to it and modifies the message to indicate that
it is still okay and has taken control. These messages are
transmitted once per minute until communications are
reestablished.
The
[I'M OK Check] button requests that the SE coordinator send
an “I’m OK” message. This is used to determine if an SE
coordinator has taken control of its outputs. The
[I'M OK Release
Control] button generates a command to the SE coordinator to
release control back to the Central Console. Normally, the Central
Console automatically generates a release control message upon
the re-establishment of communications following a failure.
[Reset Transponder] Clicking this button resets the SE coordinator as if it was just
powered up. Any test or alarm processing that was in progress at
the time is lost.
[Point Out Of Service] Clicking this button takes the currently selected point out-of-
service. That point no longer responds to the system, as if it was
disconnected. Use this function with caution.
[Point In Service] Clicking this button restores the currently selected point to an in-
service condition. That point returns to normal function.
Horn - Siren If this checkbox is selected, the horn output of an SE receiver or
the siren output is turned on if the
[On Output Command] button
is clicked, or off if the [Off Output Command] button is clicked. If
this checkbox is not selected, the state of this output is not
changed.
Green Led If this checkbox is selected, the green LED of an SE receiver is
turned on if the
[On Output Command] button is clicked, or off if
the [Off Output Command] button is clicked. If this checkbox is
not selected, the state of this output is not change.
Strobe - Red Led If this checkbox is selected, the red LED of an SE receiver or the
strobe output is turned on if the
[On Output Command] button is
clicked, or off if the [Off Output Command] button is clicked. If
this checkbox is not selected, the state of this output is not
changed.