Safety
2.2
Special safety notes
Page 6
BOGE compressor control airtelligence provis 3
– Only suitable and approved lifting and transport tools may be used for
unloading and transport.
– Never climb onto control unit or packaging.
– Protect surfaces and frame from damage.
– During transport or intermediate storage, ensure that the surfaces are
weather-protected, dry, clean and protected from external influences.
– The breaking load classes must be observed. Place insensitive parts at the
bottom.
– Observe any information on humidity and temperature range during trans-
port (see „8.1 Technical data“, page 75).
Switch cabinet
The control is installed in a separate switch cabinet.
The operating unit of the control, the touch panel, is installed in the front of the
switch cabinet.
– The control may only be operated by means of the touch panel when the
switch cabinet is closed
– Never open switch cabinet during operation.
– If necessary, switch cabinet to be opened by authorized and qualified elec-
tricians only.
Touch panel
– No pointed or sharp-edged objects may be used when operating the touch
panel. They can damage the surface of the touch panel. Only operate the
touch panel with your fingers or a suitable input pen with a plastic tip.
Fig. 2.1: Operate touch panel properly
Network
The control and configuration protocols do not provide authentication mecha-
nisms. Furthermore, large amounts of network traffic can lead to an impair-
ment of the control communication. BOGE therefore strongly recommends the
use of the controls exclusively in closed networks (technical network).
The network configuration, e.g. the IP address assignment, must be carried
out in coordination with the responsible IT department, which is also respon-
sible for the network in which the control is to be operated. Incorrect settings
(such as repeatedly assigned IP addresses, incorrect gateways, etc.) can also
lead to interference with other network participants.
Notes on cleaning the display on page 73.
