Use of the control
5.3
Component detail view
Page 56
BOGE compressor control airtelligence provis 3
The detailed description of the setting options is therefore not part of these
operating instructions. Details of possible settings in this display can be
obtained by contacting Technical Support or in the BOGE training courses.
5.3 Component detail view
Tapping a component in the list view of the status display at the level of the
compressed airnet view (see page 37) takes you to the corresponding compo-
nent detail view. In this view, current information values calculated by airtelli-
gence provis 3 are displayed on the basis of the data from the slave controls.
On the other hand, set values which are necessary for the configuration of the
component in the compressed airnet of airtelligence provis 3 are also dis-
played. The view that exists for each component of the compressed airnet is
structured differently depending on whether it is a compressor, a receiver or
equipment. All component detail views always consist of several tiles
(1,2,3,...), see the following figure. Each tile encloses related contents.
Fig. 5.17: Component detail view - compressor
CAUTION
Danger of faults or malfunctions in control behavior and damage to
components due to incorrect settings!
Incorrect or unqualified settings for the compressed airnet can lead to distur-
bances in the control behavior and damage to network components
The settings in this display may only be carried out by BOGE service per-
sonnel or qualified persons who have received BOGE training on this con-
trol.
(1)
(2)
(3)
(4)
