47
1.
From the
LIST
menu, use the key to select
Recall
and press
. The display will
say
RECALL LIST
with the prompt
Recall List File:
to ask to enter a number.
2.
This is the location number where the program is stored in. Select a number between 1
to 10 with the current adjust knob or the numeric keypad, then press
.
3.
The display will return back to the
LIST
menu.
Run Program
To run a program sequence after it is recalled, the trigger source must be configured
first
. Refer
to “Configure Trigger Source” in section 3.3 to set up the trigger source.
Follow the steps below to run the program:
1.
Assuming the stored program has already been recalled, from the
LIST
menu, with
Off
selected, press
. The
Trig
indicator will appear at the top middle of the display.
2.
Now, press
twice to exit the menu. The following will display:
3.
If the display is showing the measured voltage and current value, the
backlight
should be lit and display should show
0.000V
and
0.000A
.
4.
Now, press the
key to enable (ON) the output.
5.
If the
Trigger Source
configured in section 3.3 is set to
Manual (Def)
, then the front
panel trigger key can be used to initiate the program. Press
and then
.
6.
The program will immediately start running and the backlight of the
button will
be blinking. The
Trig
indicator will also disappear.
7.
When the program ends, the
will stop blinking and the
Trig
indicator will
reappear again.
Note: If the Trigger Source is configured to BUS, use the remote command for sending
triggers over any of the remote interface available. Refer to the programming
manual for details.
0.000V
0.000A
0.0 W
OFF Trig
LIST
