29
Return Meter
This option allows users to enable an internal fixed timer delay (5 seconds) for the power supply
to automatically switch from setting display to measured display. When enabled, if the power
supply output state is ON (enabled) and if the display shows setting voltage and current, it will
automatically switch to measured voltage and current display after 5 seconds. The backlight of
the
button will also be lit. In this state, pushing the
again to toggle back to
setting display will reset the 5-second timer again before the supply changes back to measured
display.
To configure this option, follow the steps below:
1.
From the
SYSTEM
menu, browse and select
ReturnMeter
and press
.
2.
Select between the two options:
Off(Def)
–
Return Meter function disabled.
Delay
–
Enables return meter function.
3.
Select the desired option and press
to save the change.
4.
To exit the menu at any time, press
twice.
3.4
CONFIG Menu
All setup procedures and settings explained in this section can be accessed from the
CONFIG
menu. To access this menu, press
and press
. Select
CONFIG
, then press
.
Load Setup Option
The power supply has an internal dummy load that can be enabled to increase the speed of the
voltage fall time for high speed test applications. The effectiveness of this function is
dependent on the DUT (device under test) and may or may not be useful for some applications.
This feature should only be used with caution, as it is not designed for all applications.
DO NOT enable this function for applications such as connecting devices for battery charging
