26
locked until the instrument is in LOCAL mode. To return to LOCAL mode from the front panel,
press
and
. The
RMT
indicator will disappear when the instrument is in LOCAL
mode.
RS-232
Follow the steps below to configure the power supply for RS-232 operation:
1.
From the
SYSTEM
menu, browse and select
Communication
and press
.
2.
Select
RS-232(Def)
and press
to set to RS-232 for remote communication. The
following display will be shown:
3.
4800
is the baudrate;
8
is the data bits;
N
is the parity;
1
is the stop bit;
Addr…
is for
address.
4.
Use to select between each serial settings, and use to change the settings.
5.
Below lists the options that can be changed for each setting:
Baudrate: 4800, 9600, 19200, 38400, 57600, 115200*
Data bits: 8
Parity: N
(None)
, E
(Even)
, O
(Odd)
Stop bit: 1, 2
Addr: 0 to 31
Note: The default is 4800, 8, N, 1, Address = 0.
*Setting the baudrate to 115200 may cause unstable results during remote
communication. Select a lower baudrate if communication errors occur.
6.
All serial settings must match with the settings configured on the PC in order for
communication to link successfully.
USBTMC
A
USB Type A to Type B cable
(i.e. USB printer cable) is required to connect the USB port in the
rear panel to a PC. Follow the steps below to setup the power supply for remote
communication.
1.
From the
SYSTEM
menu, browse and select
Communication
and press
.
2.
Select
USB
and press
to set to USBTMC for remote communication.
RS232
48 00 , 8 , N , 1 , Add r . . .
