Bionet CardioTouch3000, Руководство по эксплуатации

Страница: 26 / 120

26 / 120
E3KOM-7.00
CardioTouch3000 Operation Manual
▣
Battery Power
The device will get its power from the battery and the unit will display the battery power
icon (shown above), when the system is powered on, the battery is connected to the
device and the AC power is disconnected. When the battery power is low, an alarm
sound will ring from the device speaker and LCD display will show a ―Battery Low‖ message.
Connect the AC power immediately or the device will automatically shut down in 1minute.
•
Time to complete full recharge after full discharge: Max. 3 hours
•
Duration of continuous usage after full recharge: if running ECG record in 12 channel
format by choosing to set successive function for about 360 min. at 25mm/s and
10mm/mV or in the absence of ECG record, it is possible to record a max. of 200
ECG.
▣
Display Battery Power Status

: Battery Fully Charged

: Battery Charge Half-Full

: Battery Charge Low

: Battery Almost Fully Drained
▣
Replacing Battery
When replacing battery for this device, the same type of battery should be used.
•
Type: Lithium-ion battery 3ICR19/65 ( 11.1V-2600mAh )
•
When to replace: Battery will automatically be charged when the device is
connected to AC power, and cannot be charged when separated from the device.
Battery is designed to have a charging cycle of 300 times or more. If the device only
lasts 20 minutes or less on battery power, the battery needs to be replaced.
Additionally, when a battery pack is damaged or leaking chemicals, replace it
immediately. Do not use damaged battery packs with the device.
WARNING
EXPLOSION HAZARD —
DO NOT incinerate the battery or store at high temperatures. Serious injury or death
could result.