VisiPC Software Manual Part 1 – Visilynx 3 Configurator
INS00231 Issue 4 Page 42 of 88
4.8.3 Monitor Default Camera Settings
‘Monitor Default Camera Settings’ allows you to assign different default camera numbers to
the selected monitor, when camera mapping is enabled. This will only appear if you have
defined one or more camera maps in the ‘Global System Settings’ screen (see page 21).
There are three possible events which will cause the use of default camera settings, as
follows:
•
When the remote control default camera command is used. This will be generated by an
external device using Visilynx 3 or PCCON remote control protocol.
•
When the system is reset using the pushbutton either on the back panel of a V3i unit or
on the CPU card of a V3M system.
•
When the system is switched on for the first time after loading a new configuration.
Note: For V3M systems only, a second camera map ‘Map 2’ is available, but it is only useful
for trainborne rack systems, to accommodate two directions of travel. If you are not
operating a trainborne rack, do not select more than one Camera Map in the ‘Global System
Settings’ screen.
Figure 41 Monitor Default Camera Settings Screenshot
•
Use the
Monitor
selector (bottom right) to select the one to configure.
•
Camera
: The camera allocated to the selected monitor
•
Node
: The node on which the camera resides
•
Accept
: will save the settings for the current page.
•
Restore
: will return all of the settings on the page to the point when the configuration was
last saved using
Accept
.
