Belden Grass Valley Kayenne K-Frame, Инструкция по установке и обслуживанию

Страница: 158 / 288

158 KAYENNE K-FRAME — Installation & Service Manual
Section 5 — Basic Configuration
You now have device control over this ClipStore resource, and it can be
mapped. Repeat the preceding steps for each ClipStore channel.
Configuring Outputs
Set the switcher outputs that are feeding into ClipStore. By selecting an Aux
bus then touching one of the CS-1 through CS-4 enable buttons, those Aux
bus outputs will be paired. In other words, if you select the output, then
Aux 5, Aux 5a and Aux 5b will be paired as a ClipStore Video/Key pair
when the ClipStore button is enabled.
1.
Go to the Outputs menu by touching
Eng Setup
,
Outputs
.
2. Select the odd numbered output (first Aux bus output assigned for a
video/key pair must be odd/fill) that you wish to use as the input to
ClipStore. Then select Aux as the Output Type and the desired logical
Aux bus.
3. Touch one of the ClipStore buttons.
4.
Repeat the preceding steps for each channel of ClipStore.
Note You only need to configure all channels as video/key if you wish to record on
all channels.
The Engineering Names for each ClipStore channel will appear in the
Local Aux area and/or can be button mapped as desired.
Acquire and Assign CS channels in another suite
1. In the Outputs menu, deselect the CS channels to be acquired.
2.
Touch the
Suite 1
or
Suite 2
button to change suite delegation.
3. Re-acquire the CS outputs by touching the CS buttons (CS-1, CS-2, etc.).
It is recommended at this point that you save a new Eng Setup file that
includes these changes.
ClipStore Config Menu
The ClipStore Config menu is used to configure the ClipStore input/output
parameters and read those input/output parameters from, or send them to,
the ClipStore server.