Belden Grass Valley Kayenne K-Frame, Инструкция по установке и обслуживанию

Страница: 127 / 288

KAYENNE K-FRAME — Installation & Service Manual 127
About Network Configuration
Restoring the Default IP Address
You need to know the current IP address of the Remote Aux Panel in order
to change it using the Web browser. If a panel’s IP address has been
changed and its new value not recorded, it will be impossible to change its
IP address. You can restore the panel to its factory default address, if neces-
sary, with the following procedure.
1.
Disconnect the Ethernet cable and the AC power cable from the Remote
Aux Panel.
2.
Reconnect only the AC power cable. The panel will enter a diagnostic
mode.
3.
Push down and hold any panel button. After three seconds panel
buttons will light up sequentially, indicating different available
diagnostics.
4. When three buttons illuminate, release the held button. This places the
panel in IP Address reset mode, and one button will be flashing.
5. Press the flashing button. This resets the IP address to factory default
(see
Factory Default Network Settings on page 92 ).
Configure 10GigE IP I/O Addresses
Modular Internet Protocol (IP) addresses must be unique for inputs and
outputs. To help with configuring Modular IP Addresses sequentially you
can use the Auto Complete button to auto-fill a column sequentially, down-
ward, beginning with the currently selected IP address.
Note TICO compression is not currently supported although it is available.
1. To configure Modular IP addresses, begin with the Input Local IP:
a. Select an Input Local IP address data pad; a pop-up keypad
displays.
b. Enter the new IP address and select
Enter
.