Belden Grass Valley Kayenne K-Frame, Инструкция по установке и обслуживанию

Страница: 113 / 288

KAYENNE K-FRAME — Installation & Service Manual 113
Power Up and Initialize the System
to indicate the state of that parameter. For on/off buttons, green indicates
this is a normal parameter and that either an on or off state is typical.
Yellow indicates an active function that may change expected behavior.
Red indicates an active function which significantly changes normal
behavior.
Data Pads and Soft Knobs
Data pads on the right side of the screen allow adjusting parameters
with ranges of values. Left clicking or touching a data pad opens a
numeric keypad, allowing entry of a specific value.
When equipped with a Touch Screen Menu Panel, knobs along the
right side of the panel can be used to dial in parameter values for
functions displayed. When a knob is active, the touch screen shows
the parameter name and its current value on that data pad
(
Figure 76 ).
Menu Selection
Various GV Switcher system operating menus are selected using the menu
buttons at the bottom of the Menu panel touch screen. Menu category selec-
tion touch buttons are directly above the
Menu
touch buttons. Touching one
of these buttons displays that category (see Figure 75 on page 112 ).
As each menu is accessed, a button for it appears in the scrolling
History
pane on the left, providing a quick return to that menu.
Favorites
can also be
programmed for quick access to specific menus that are not overwritten.
Note The optional eDPM system has its own set of operating menus, accessed by
touching the
eDPM button on the lower left. For basic Kayenne K-Frame con-
figuration be sure the SWR button is selected.
Power Up and Initialize the System
The Kayenne K-Frame Video Processor Frame, Control Panel, and menu
application must be running for full system operation.
1.
Turn on the Kayenne K-Frame Video Processor power switch located
inside the front door, on the front of the control board (see
Figure 47 on
page 71 and Figure 53 on page 76 ).
CAUTION The front doors of the Video Processor Frame must remain closed during
normal system operation for proper cooling airflow.
2. Turn on the PCU power switch located inside the front door, near the
center of the upper board of the unit (see
Figure on page 230 ).
Soft Knob
Label
Soft
Knob
Data
Pad
8804_47
Figure 76. Soft Knob and Data Pad