Belden Grass Valley GV Korona, Руководство пользователя

Страница: 316 / 433

316
Advanced Operations
Local E-MEM in Split Mode (Kayenne/Karrera)
Local E-MEM in Split Mode (Kayenne/Karrera)
When the M/E bank of a split M/E is delegated to one partition, that M/E’s Local E-MEM will
control only that partition’s E-MEM registers. Learning, recalling, and running effects will
only occur on the currently selected partition.
When the M/E bank is delegated to both partitions, effect recalls and runs are initiated in
both partitions and are controlled simultaneously.
When effect registers are saved to disk, all the levels of that effect are saved, including
information for both partitions of a split M/E.
Master E-MEM in Split Mode
The Master E-MEM allows for enabling the M/E levels. If the M/E is not split then all M/E
control except for ME Mode is with the ME Primary level and the ME Secondary level is
disabled. When the M/E is split then the control for the Secondary is with the ME Sec level.
The ME Mode is controlled by the ME Partition sub-level. ME Mode includes ME Split Mode,
the assignments of the Keyers, Layered Mode and configuration of the ME PGM outputs.
The Partition Level by default has the M/E partition sub-level for each of the M/Es. The M/E
partition sub-level can be assigned to other levels. It's recommended that if having an M/E
level control its own partitioning is desired, then the Primary ME level should be used. If the
M/E partition sub-level is assigned to an ME Secondary level, there is a potential for that
level to be disabled and the partition sub-level with it.
Split M/Es and E-MEM Control
When an M/E is split, the Primary and Secondary partitions each have their own essentially
separate E-MEM system. How each of these partitions are controlled by E-MEM operations
depends on the E-MEM Prefs settings for that M/E.
M/E Copy in Split Mode
The Copy/Swap function can be used to copy M/E settings from one location to another. ME
Copy and Swap operates on the entire M/E regardless of mode or secondary assignments.
For example, if a source M/E is split and the destination M/E is not, after a copy both M/Es
will be split. Swaps behave in a similar manner, with the split setting and resource
assignments being swapped between the M/Es.
Partition Boundaries
The ME mode (Normal, Prog CF, and Layered Mode when in Split mode), output, and any
secondary assignment information is stored as partition boundary information in the
E-MEM system itself. This makes it possible to change an M/E’s mode with an E-MEM recall.
This partition boundary information is maintained as a separate component to permit
isolation between Primary and Secondary partitions. See
Partition Boundary Control , on
page 317.