Belden Grass Valley GV Korona, Руководство пользователя

Страница: 280 / 433

280
Advanced Operations
Building Keyer E-MEM Transitions
10 Rewind and run the effect to check its operation. The transitions will occur as
programmed.
11 After the effect runs properly, you can go back and modify keyframes with Source
Holds where needed.
Building Keyer E-MEM Transitions
Individual keyers transition on or off (there is no keyer preset bus). To cross fade between
keys, use two keyers and have one key transition in while the other transitions out. You can
include any combination of keys in a single transition, using the transition rules to
determine the exact behavior of the transitioning keys.
1 Go to the keyframe in the effect where you wish the key transition(s) to begin.
2 Select the Key 1 , 2 , etc. next transition button(s) for the keyer element(s) involved.
Selected keys that are on will transition off, and keys that are off will transition on.
3 Select the type of transition ( Mix , Wipe 1 , or Wipe 2 ).
4 Press Modify to change the keyframe to the values set above.
5 Change the on/off state of the keys you wish to transition.
6 If you are transitioning in a new key, select the source on that key bus. If you are
transitioning out a key, do NOT change the source selected on the key bus for that
keyer (this prevents an unwanted cut).
7 Press Insert After to add this keyframe to the effect.
8 Repeat the steps above for any additional keyer transitions.
9 Rewind and run the effect to check its operation. The transition(s) will occur as
programmed.
Changing the Length of an E-MEM Transition
In the menu, change the keyframe duration of the first keyframe involved in that transition.
1 Go to the first keyframe for that transition.
2 Press KF Duration and then enter a value in <seconds • <frames> • <fields> format on
the keypad.
3 Press Modify KF.
Preventing Elements from Transitioning in E-MEMs
To ensure a transition for an element does not occur, simply make sure the next transition
button for that element is off in the keyframe by selecting another element’s button.
To ensure no transition occurs at all at a keyframe (any changes will be cuts), you can select
only the next transition button for a keyer and make sure its state does not change in the
TIP: If unwanted background cuts occur, go to the keyframe where the
cut occurs, identify the source selected on the A bus, go to the
previous keyframe, select that same source on the B bus, and then
press
Modify KF to properly setup that source in that keyframe for
that next transition.