Belarus 3522.5, Руководство оператора

Страница: 255 / 340

3522.5-0000010 OM
256
ATTENTION: MANUFACTURER OF THE IMPLEMENT CARDAN-DRIVEN FROM
THE TRACTOR PTO SHAFT, SHAL INFORM YOU IN ADVANCE ABOUT THE NECES-
SITY OF APPLICATION OF A SAFETY CLUTCH, CLUTCH DESIGN FEATURES AND
CONSEQUENSES OF THE IMPLEMENTS APPLICATIONS WITHOUT THE SAFETY
CLUTCH!
When you need to decide on the purchase or operation of the cardan shaft follow
the implements and cardan shaft manufacturers’ guidelines first of all. It is recommended
to apply with the tractor the implements with active working attachments where the length
between the articulations of the fully off-set cardan shaft does not exceed 1 m.
When coupling the implements with RLL or FLL (Figure 5.7.2), the length of the car-
dan shaft is determined by distance L (fully off-set cardan shaft) with the lower drawbars
placed horizontally. Shaft extension occurs when the implement is lifted therefore in up posi-
tion it is necessary to check overlapping of extensible components. In joint of the cardan shaft
large angularity appears in transport position of the implement when the tractor PTO shaft is
disabled. Cardan joints are not large and equal to each other in operating position, and usu-
ally L
1
=L
2
is assured. Therefore in this case an extensible cardan shaft with gimbal joint with
guard housing can be used.
Figure 5.7.2 – Cardan shaft length finding scheme in course of the tractor coupling
with the implements connected via RLL and FLL.
In course of the implements coupling via “Draw bar” (Figure 5.7.3) where PTO shaft
and PRS are parallel and not shifted relative to each other in fore-and-aft plane (right and
left), distances A and B from the connection point to PTO shaft and to PRS are approxi-
mately equal, and maximum length of cardan shaft L is determined when the implement
turns around maximum angle turn relative to the tractor, an extensible cardan shaft with
gimbal joint with guard housing can be used.
Figure 5.7.3 – Cardan shaft length finding scheme in course of the implements cou-
pling via (Figure 5.7.3).
https://tractormanualz.com/