Belarus 3522.5, Руководство оператора

Страница: 241 / 340

3522.5-0000010 OM
242
In construction of rear LL a possibility of use of an adjusting rod which by fixing of
the lower drawbars of a certain size among themselves ensures necessary length of a
suspension axis and facilitates their connection to an implement. For protection of coupled
implements from rocking length adjustable limit external rods are used.
To ensure the implement is in the right position the following adjustments of RLL by
means of upper drawbar, crossbeams and limit rods are provided in vertical and horizontal
plane:
1 Modification of length of upper drawbar.
Modification of length of upper drawbar is carried out in order to ensure penetration
of operative parts (alignment of running depth of operative parts located one after another
along the tractor run). If mounted plough carriage reaches forward along the tractor run
and the front plough body cuts deeper than the rear one, extend the upper drawbar; and if
the front plough body cuts for the more shallow depth than the rear one, the upper drawbar
shall be shortened.
2 Modification of length of left or right crossbeam.
The modification is carried out in the following cases:
- to ensure the implement is in the horizontal plane;
- to ensure the even depth processing with operative parts of tractor-mounted ma-
chine across the width of cut;
3 Modification of length of both crossbeams, upper drawbar for transport position of
the implement.
The modification is carried out in the following cases:
- to ensure the road clearance is not less than 300 mm;
- to ensure the sufficient safe clearance between the elements of the tractor and the
implement, excluding the contact of parts of the tractor implements (clearance is not less than
100 mm).
4. Modification of length of both.
The modification is applied for the following purposes:
- during transportation of the implement, fasteners shall be blocked for the limitation
of the implement rocking at run for the avoidance of the tractor elements damaging in case
of an incidence;
- during operation of mounted, semimounted tilling machines with passively oper-
ated parts for the full processing (share and chisel ploughs, shallow ploughs, rippers and
other implements), free movement in horizontal plane (rocking) shall be ensured, and the
fasteners shall be unblocked as indicated in subsection 3.18.2 “Drawbar”;
IT IS FORBIDDEN TO OFFSET THE LONGITUDINAL AXIS OF THE IMPLEMENT,
CONCERNING THE LONGITUDINAL AXIS OF THE TRACTOR BY MEANS OF AD-
JUSTMENT OF FASTENERS.
Note – Rules on adjustment of the crossbeams are specified in subsection 3.18
“Rear lift linkage”.
ATTENTION: LENGTH OF THE LEFT CROSSBEAM OF THE REAR LIFT LINK-
AGE MAKES 1020 MM, WHICH SHALL NOT BE CHANGED WITHOUT PARTICULAR
NEED. IT IS USUALLY THE RIGHT CROSSBEAM THAT IS LENGH ADJUSTABLE.
WHEN THE CROSSBEAM IS USED ON THE SUSPENSION AXIS AND WHEN RE-
VERSIBLE PLOUGH IS USED THE LENGH OF CROSSBEAMS SHALL BE ALL THE
SAME!
ATTENTION: NONCOMPLIANCE WITH THE REQUIREMENTS FOR ADJUST-
MENT OF FASTENERS AND CROSSBEAMS MAY RESULT IN FASTENERS OR SUP-
PORT BRACKET BREAK OR OTHER BREAKAGE!
ATTENTION: ESSENTIAL FEATURES AND WAYS OF ADJUSTMENT OF POSI-
TION OF THE IMPLEMENT COUPLED WITH MOUNTED DEVICES ACCORDING TO
THE PECULIARITIES OF TECHNOLOGICAL PROCESS EXECUTION AND AGRO-
TECHNICAL REQUIREMENTS ARE SPECIFIED IN OPERATIONAL DOCUMENTATION
OF SUCH IMPLEMENTS. IF THERE IS NO INFORMATION IN OPERATIONAL DOCU-
MENTATION, YOU SHALL OBTAIL IT FROM THE MANUFACTURER OR SELLER OF
THE IMPLEMENT!
https://tractormanualz.com/