Beckman Coulter Allegra X-14 sERIES, Инструкция по эксплуатации

Страница: 45 / 54

PN B07493AD
A-1
APPENDIX A
Installation
Introduction
Preinstallation requirements have been sent prior to shipment of your centrifuge.
WARNING
This centrifuge weighs 128 kg (283 lb). Do not attempt to lift or move it without
assistance.
Space and Location Requirements
WARNING
Do not place the centrifuge near areas containing flammable reagents or
combustible fluids. Vapors from these materials could enter the centrifuge
air system and be ignited by the motor.
The centrifuge ships in a cardboard box on a wooden pallet. For easy access, remove the top of the
box, the foam insert on top of the centrifuge, and then the upper part (sides) of the box and set them
aside for possible future transportation/storage. Then, with the help of additional person(s) and/or
equipment , move the centrifuge from the pallet to its final position.
1
Select a location away from heat-producing laboratory equipment, with sufficient ventilation
to allow for heat dissipation.
• The centrifuge must have adequate air ventilation to ensure compliance to local
requirements for vapors produced during operation.
2
Position the centrifuge on a level surface, such as a sturdy table or laboratory bench that is able
to support the weight of the centrifuge (128 kg/283 lb) and resist vibration.
a. Make sure that the centrifuge front feet are fully supported on the table.
3
In addition to the space for the centrifuge itself, allow 7.6-cm (3-in.) clearances at the sides and
back of the centrifuge to ensure sufficient air circulation.
• Dimensions are shown in Figure A.1 .
• Additional clearance is required on the left side to allow access to the power switch.