Beckman Coulter Allegra X-14 sERIES, Инструкция по эксплуатации

Страница: 31 / 54

PN B07493AD
2-7
Operation
Manual Operation
2
1
Press
ACCEL
, then use the keypad or arrow keys to select the required acceleration rate.
•
Entered acceleration rate appears on the display.
2
Press the next run-parameter key or
ENTER/SAVE
.
3
Press
DECEL
, then use the keypad or arrow keys to select the required deceleration rate.
•
Entered deceleration rate appears on the display.
4
Press the next run-parameter key or
ENTER/SAVE
.
Starting a Run
NOTE
Wipe out moisture from the chamber and the chamber gasket before each run.
1
Press
ENTER/SAVE
and
START.
• The light next to the
START
key flashes and the rotor begins to spin.
NOTE
To begin a run,
ENTER/SAVE
must always be the last key pressed before pressing
START
. If
you wait more than 5 seconds, the START key will not activate. If this happens, press
ENTER/SAVE and START again to begin the run.
• The run will end when the time display counts down to zero.
6
5
4
3 2:45
3:07
3:36
4:18 2:49
3:15
3:42
4:26 2:33
2:53
3:20
4:00 2:38
3:00
3:27
4:08 2:45
3:07
3:36
4:19 2:51
3:12
3:44
4:26 2:33
2:54
3:20
4:01 2:38
3:02
3:28
4:09 5:26
6:27
7:31
8:33 5:29
6:30
7:29
8:33
2
1 (SLOW)
0 (OFF) 5:21
7:06
— 5:29
7:16
19:41
4:58
6:36
— 5:06
6:46
16:12
5:20
7:06
— 5:29
7:19
19:27
4:59
6:36
— 5:07
6:46
15:53 9:36
10:11
—
9:31
10:07
18:32
a. Times shown are with the rotor fully loaded in the Allegra X-14R. (Times are approximate; actual times will vary depending on the rotor in use,
the rotor load, run speed, and voltage fluctuations.)
Table 2.1
Acceleration and Deceleration Rates (in Minutes:Seconds) to and from Maximum Speed
a
Rate SX4750 SX4750

SX4750A SX4750a FX6100
(4300 RPM) (4000 RPM) (4300 RPM) 4000 RPM (10,200 RPM)
Accel Decel Accel Decel Accel Decel Accel Decel Accel Decel