Beckman Coulter Allegra X-14 sERIES, Инструкция по эксплуатации

Страница: 20 / 54

PN B07493AD
1-6
Description
Name Rating Plate
Name Rating Plate
A name rating plate is affixed to the rear of the instrument. Always mention the serial number and
model number when contacting Beckman Coulter regarding your centrifuge.
A toggle switch used to enter into and exit out of the program mode to create or recall
programs. When the key is pressed, the program number can be selected using the
keypad or arrow keys.
Up and down arrow keys, which can be pressed to increment parameter values up
or down.
The ENTER/SAVE key can be pressed to save parameter inputs to system memory
during manual run setup or to a program during a program set up, and to start the
centrifuge ( ENTER/SAVE , then START must be pressed to start the centrifuge).
The keypad is used to enter numerical run parameters, to enter or recall a program
number, and to select acceleration and/or deceleration rates. In addition to keys 0
through 9, the keypad includes a plus/minus key and a CE (clear entry) key.
The CE (clear entry) key clears any parameter on the display. Pressing CE will also
clear some diagnostic messages. If a diagnostic message does not clear when CE is
pressed, see CHAPTER 3, Troubleshooting .
Pressed during a run to display set values for 5 seconds.
Causes the rotor to accelerate, at maximum rate, to set speed for short-duration runs
(as long as the key is pressed). Deceleration, at maximum rate, begins when the key
is released.
Pressing ENTER/SAVE , then START begins the run. ( START must be pressed within
5 seconds of pressing ENTER/SAVE.) This key combination can also be used to abort
a deceleration process and restart the centrifuge.
Can be pressed at any time while the rotor is spinning to terminate a run. The
centrifuge decelerates to a complete stop according to the deceleration setting. The
green light next to the key flashes while the rotor decelerates. A tone sounds when
the rotor comes to a complete stop. (Instructions for disabling the tone are in
CHAPTER 2 .)
Unlocks and opens the door. (The instrument will not accept the unlock command if
the rotor is spinning.)