Baxi Senertec Dachs Pro 20 ST, Руководство по сборке и эксплуатации

Страница: 94 / 118

14/4798.495.002 94 | Commissioning
Dachs Pro 20 ST
7.3 Commissioning procedure
Note:
Control of the unit during commissioning is performed via the CHP control panel and the menu of the MSR Pro
20 ST controller.
These instructions only describe the entries
required for commissioning.
i
See also chapters 8 and 9
Attention:
Initial commissioning of the unit may only be carried out by authorised specialist personnel.
Install the pre-fuses and check the connection in the main and sub-distribution.
!
►
First, switch on the MSR Pro 20 ST at the main switch.
►
Afterwards, switch on the CHP unit at the main switch.
● Line 1 displays:
->
Commissioning required
.
►
Carry out initial commissioning by working through 11/6/2
Commissioning menu
step by step.
For a detailed description of the settings to be made, refer to
chapter 7.6 Commissioning settings.
►
Press the illustrated button until the
green LED next to the
AUTOMATIC
symbol flashes (top LED).
●
The Dachs is then operational.
Not before all settings have been made, the Dachs can be put into
operation by pressing the
ON/OFF
key at the control panel.
Note:
In case of any irregularities during the functional check, after commissioning or
during the first days of operation, please contact a SenerTec service partner.
i
Reference:
Please observe the supplementary instructions and information in the iav
Documentation of VW on the EcoBlue 2.0 (Generation 1.2) in particular.
Chapter 7 - CHP controller settings
Chapter 8.8 - Commissioning mode
Chapter 11 - Commissioning
Chapter 14 - Acceptance protocol - CHP commissioning
For detailed information on operation of the MSR Pro 20 ST controller, please refer
to the MSR Pro 20 ST operation and configuration instructions , art. no. 4798.494.xxx.