Baxi Senertec Dachs Pro 20 ST, Руководство по сборке и эксплуатации

Страница: 52 / 118

14/4798.495.002 52 | Installation
Dachs Pro 20 ST
Fig. 36: Suspension of the MSR Pro 20 ST at the CHP
Suspension of the MSR Pro 20 ST at the CHP
►
Suspend the pre-assembled MSR Pro
20 ST as illustrated from above at the
hinge pin 5 .
No additional attachments or fixtures for the
MSR Pro 20 ST at the CHP are required.
On swivelling back, the MSR Pro 20 ST
automatically attaches to the left cladding
of the CHP using magnets at the controller
housing.
Suspension of the MSR Pro 20 ST at
the CHP
Note:
The hinged design of the controller
mounting allows the MSR Pro 20
ST to be swivelled to the side or
back
at any time
for installation or
mounting and to remove the left
cladding.
i
Note:
The transfer lines included in the scope of delivery of the CHP (heating water hoses with ball valves) cannot be
connected directly to the buffer vessel. The connection lines between the transfer at the respective ball valve of
the heating water hose to the buffer vessel are to be provided and dimensioned on site.
i
Note:
Using the slotted holes (4) for screw
connection at the hinge plate of the
controller mounting, the MSR Pro 20
ST can be precisely aligned.
i
5
6.2.4 SE940 buffer vessel installation
The Dachs Pro 20 ST design enables CHP-independent positioning of the buffer vessels on the left side, right side or behind
the CHP. However, the specified installation conditions and clearances have to be complied with.
The SE940 buffer vessels can be positioned on floors without special foundations. However, the floor has to provide sufficient
load capacity. On uneven floors, appropriate underlays are to be applied to ensure safe support of the buffer vessels. A frost-
protected room is to be selected for installation if no frost protection agent is to be used in the heating system. Otherwise,
the buffer vessel has to be discharged if there is a risk of frost.