Barudan BEXS, Инструкция по эксплуатации

Страница: 197 / 233

Threading the Sewing Head
The machine is shipped with each needle pre-threaded. To quickly change the thread, place
the new cone on the thread stand. Blow the thread through the tube and tie the end to the
thread that is threaded through the tension unit with a square knot and gently pull it through
the sewing head. Repeat for each needle. To completely re-thread a sewing head, follow these
steps which correspond to the diagram on the facing page.
Threading a Z
15
Head
Refer to Diagram on the previous page.
Preparation for threading the sewing head:
• Remove the felt pad covering the first thread guide.
• Double up the end of the thread and twist.
• Before placing cones of thread on thread stand, notice that each tube is
numbered according to needle.
• Place a circular felt pad and cone of thread on each spindle of the thread
stand.
• Insert the twisted end of thread in the end of the tube.
1.
Using canned or compressed air, blow air into the tube and release the thread. The
thread will immediately blow through the tube and out the first guide.
2.
Snap the thread into the slotted post of first tensioner (from right to left).
3.
Take the thread from the right to left of the detector wheel and wrap it clockwise
one time around the wheel..
4.
Pull the thread to the right of the tensioner assembly and wrap it clockwise one
and one-half times between the nylon wheels and over the take-up spring.
NOTE: To ensure proper threading, pull the thread down, and check that
the take-up spring bounces up and down with the thread movement.
5.
Thread through the top thread guide.
6.
Thread through the next guide.
7.
Thread through the third guide.
8.
Pass the thread to the right of the take up lever, then through the next thread guide
from back to front.
9.
Thread the eyelet in the take-up lever from right to left.
10.
Thread through the next thread guide.
X
Series Mechanical Guide 1-9