13‐10
Message
(Code)
Description Trouble
shooting
D25
Stopped for Thread Break
Message that machine stopped due to thread break.
Fix thread break and continue. If thread is not broke
(false thread break) check that thread is wrapped
around the thread detect wheel on the tension
assembly.
If false thread breaks occur on small stitches try
increasing MC parameter #19, T-Break to a higher
value.
D26
Pulse Motor Circuit
Overheat
Message that the machine stopped because the pulse
motor drive (pantograph) circuitry has over heated.
Power off the machine to let it cool down.
Check and clean the fan and fan opening to make
sure lint or other debris is not blocking them.
Afterwards, power back On, and check that the fan
is working. If fan works and still getting D26 error,
call tech support.
D27
Stopped for Temporary
Repair Stop
Message that a temporary stop code was inserted in
the design on the last run.
D28
No further Stitch Back or
Automending due to Color
Change
This is a message saying you cannot back up any
further unless you do a manual trim. Do a manual
trim.
D29
Servo Driver Error
Something jammed the pantograph while sewing, or
there is a problem with the Servo electronics. Power
off machine and make sure pantograph is not
jammed by trying to move by hand. Remove any
binds before powering on again. If no binds, power
back On and see if it’s OK. If still a problem, call tech
support.
D30
Head/Duct Board Switch
Error
More than 2 switches on the Head/Duct board are
ON. Please check and make sure switches are set
properly. Check ribbon cable from head switch
boards to head duct boards. An unplugged or
damaged cable from one board will cause this error.
D31
Driver Box/Board
Communication Error
Problem with Automat recognizing that the Driver
board is connected. Check cables from Automat to
Driver board. Call tech support.
Содержание BEXS
