13‐8
Message
(Code)
Description Trouble
shooting
D06
Main Motor Trip Error
Try to restart the machine. If still getting error, turn
Off and try rotating sewing head by hand and check
for binds (To rotate the sewing head, remove the
main drive pulley cover to get to the degree wheel
and turn the degree wheel). See D07 trouble
shooting for possible binds.
D07
Main Motor Overload
Error
Turn Off machine and rotate sewing head by hand
and check for bind (To rotate the sewing head,
remove the main drive pulley cover to get to the
degree wheel and turn the degree wheel). If binding,
take off the throat plate and check for thread
wrapped around back of the sewing hook or sewing
hook area.
Try oiling the machine to see if it’s easier to rotate. If
you cannot find bind, call tech support for help.
D08
Frame Limit Error
Message that the pantograph is beyond one of the
soft limits as set in the MC parameters. Re
-
center
the origin of design so it traces inside the limits
without getting this error. Call tech support if soft
limits need to be reset or changed in MC parameters.
D09
Start/Stop Switch Error
This error means there is a problem with either the
start or stop switch being stuck on. Check switches
and wiring.
D11
Rotary Encoder Error
Problem with encoder. Call tech support.
D12
Trimmer Slider Error
Trimmer slider is stuck in down position or caught
on un
-
trimmed thread. If caught on un
-
trimmed
thread, break thread by hand and pull about 2
inches (50mm) of thread before letting the trimmer
slider pull thread up into the thread catch. If
machine continues to have D12 errors because it’s
not trimming, check and adjust the trimmers.
Replace blades and wave washer if necessary.
If D12 is happening because slider is sticking, check
slider operation by hand and clean or repair as
necessary for smooth operation.
Содержание BEXS
