Barudan BEXS, Инструкция по эксплуатации

Страница: 150 / 233

１１‐５
Icon Parameter
Function/Action
Range Of
Value
Default
Value
6
Trim Type
0 = Trimmers OFF
1 = Pantograph moves 0.4 mm to the left before
needle penetrates and thread is trimmed.
2 = Pantograph moves backwards, then needle
penetrates and the thread is trimmed.
3 = Same as 1, but slider pulls thread before
trimming.
11 = The remnant of the upper thread under the
fabric (at the start sewing/after trimming)
will be shorter than normal length. Setting
11 opens the Thread clamps after the trim
cycle to release the top thread tension on the
check springs.
0 – 11
1
7
Trim Dir
Sets the direction the pantograph moves after a
thread trim.
0 = Moves in the H direction towards machine
origin.
1 = Moves in the V direction towards machine
origin.
0 - 1 0
8
Trim Vector
Determines the distance in (0.1mm) that the
pantograph moves before a trim.
The function only activates when M/C is equipped
with MK-6 trimming device.
0 – 50
[0.1 mm]
15
9
Low Speed
Selects the speed at which the Low Speed
function will operate. Determines the slow speed
for precise stitches such as appliqué embroidery.
Low speed function code needs to be inserted into
design data in order to activate this parameter.
M/C sews at slow speed after m/c reads low speed
function code. A high-speed function code needs
to be inserted and read to go back to normal
sewing speed.
200 to max.
speed
[rpm] 450
10
Jump Divide
Selects maximum stitch length that the m/c sews
in a single head revolution. A stitch longer than
the programmed values is divided into two
stitches. E.g. if set at 80 (8mm), when the m/c
encounters a stitch 10mm long, it will divide it
into two stitches.
*Move-offs may occur when 15 & 20 head m/c are
sewing long stitch as on caps with cap frames due
to the weight of the frames. In that case, the
problem may be corrected by lowering the value
(try 40 - 70).
*If different m/c /fabric/design with various stitch
lengths cause unexpected speed changes while
sewing, this value can be changed to fix the
problem (try 40 - 70).
*Needle breaks while sewing hard, overlapping
fabric with long stitches may be corrected by
lowering the value (try 40 - 70).
30 – 127
[0.1 mm]
127