13‐9
Message
(Code)
Description Trouble
shooting
D13
No further Stitch Back or
Automending due to 1600
stitch limit
Message that machine cannot stitch back or
automend any further due to 1600 Stitch limit. If
needing to stitch back/automend further, use float
operation, and float back where needed. See
operation manual for Float instructions.
D14
Push Start Button
Message that start button needs to be pushed to
continue operation.
D16
Bobbin Break
(Optional Bobbin sensor equipped) Message that
machine stopped due to bobbin thread break. Fix or
replace bobbin thread.
D19
Stopped for Stop Code
Message that machine stopped due to stop code in
design.
D20
End of Automending
Message that machine stopped due to Automend
operation finished.
D21
Stopped by Stop Switch
Message that machine was stopped by the stop
switch
D22
Trimmer Motor Error
Trimmer motor is jammed or not stopping in the
correct position.
You must turn machine Off to reset this error.
Check the trimmer blade adjustment.
Birdnesting of thread will knock trimmers out of
adjustment when trying to trim. Remove any excess
thread from under throat plate and reset trimmer
blade if needed.
D23
Stopped for Appliqué
Message that machine stopped due to stop code in
design and Appliqué program feature is turned On.
Содержание BEXS
