Barudan BEXS, Инструкция по эксплуатации

Страница: 220 / 233

Chapter 2 Machine Care
Cleaning the Machine
It is important to clean the machine before oiling. Keep all areas of the machine clean of
built-up lint and dust.
• You should have both soft-bristle and stiff-bristle brushes and a shop vac
available for routine cleaning.
• An air compressor is useful for cleaning hard to reach areas.
• A mild spray cleaner can be used on the table top to clean up excess oil
that may splatter when the machine is oiled.
• Periodically vacuum the vents of the driver box. Do not use compressed
air to blow the vents clean, as this will force debris into the driver box.
A maintenance log, attached to the machine, is recommended. Keep a chart of the
maintenance/oiling schedule, performed on the machine.
Bobbin Case Maintenance
In a normal production setting, the bobbin case should be cleaned
every 4 - 6 hours
. Brush
lint and dust out of the bobbin case. Failure to keep the bobbin case clean can cause tension
problems. If tension is adjusted without first removing dust and lint, the tension spring on the
bobbin case can be bent too far and the case will need to be replaced.
Cleaning the Bobbin Case
1.
When the case is removed for cleaning, check the shaft for wear.
2.
Brush lint and dust out of the case with a small soft-bristle brush.
3.
Replace the bobbin in the case and test the tension, as detailed on
page 1-22.
Hook Assembly Maintenance
The hook assembly should be
cleaned every 4 - 6 hours
when the machine is used in a
normal production setting. The hook assembly should be
oiled every
4 to 6 hours.
Cleaning the Hook Assembly
1.
Remove the bobbin case from the hook assembly.
2.
Brush any lint or dust from the hook assembly with a small stiff-bristle brush. If
you can’t remove all the lint/dust with a brush, use compressed air to blow the
hook assembly clean.
X
Series Mechanical Guide 2-1