Barco ScreenPRO-II, Руководство пользователя

Страница: 40 / 292

40 ScreenPRO-II Controller • User’s Guide
2. Hardware Orientation
Front Panel Sections
Next — press to recall the next valid Preset in sequential order. Please note:
•
If Preset 2 is lit, pressing Next recalls Preset 3 .
•
If Preset 6 is active on page 2 , pressing Next advances to Preset 1 on page 3 .
•
If a Preset is undefined, it will be skipped when Next is pressed.
Previous — this function is currently not implemented.
Page — hold down Page , then press the desired Preset button to switch to that page of
Presets. The Red LED above the button lights to indicate the selected page.
S
To switch to page 5, press Page + 5 .
In Chapter 6, refer to the “ Working with Presets ” section on page 243 for complete
instructions on all Preset modes.
aÉëíáå~íáçåL^ìñ=_ìë
The figure below illustrates the Destination/Aux Bus :
Figure 2-4. Destination/Aux Bus
Each numbered button on the Destination Bus represents a location to which you can
route some form of controller (or router) output. The transitions that you perform will affect
the selected destinations only, leaving the unselected destinations as they were. The
ScreenPRO-II Controller provides eight destinations — four standard (e.g., projectors) and
four Aux (auxiliary).
Next
Previous
Page
Note The Page button is also used (in conjunction with the ALL
button) to lock and unlock the Controller. In Chapter 6, refer
to the “
Locking and Unlocking the Controller ” section on
page 252 for details.
1 2 3 4
DEST
AUX
DESTINATIONS / AUX
ALL
Important Operationally, remember that the Destination/Aux Bus is
one bus — it is not two separate and independent buses.
•
Any source selection will apply to all enabled buses.
•
Any transition will apply to all enabled buses.