Barco ScreenPRO-II, Руководство пользователя

Страница: 197 / 292

ScreenPRO-II Controller • User’s Guide 197
5. System Setup
AUX Destination Setup
7. On the Source Mapping line, two choices are available:
~
Select Input Patch if you want to map Aux sources according to how
inputs are patched to buttons on the Source Selection bus. Note that
this is the typical choice.
~
Select Direct Map if you want the Source Selection bus to be a 1:1
mapping of your router inputs — for this Aux destination only.
8. On the ID line, select the ID of the ImagePRO or PrePRO -II to which you want to
route Aux sources.
9. In the Analog section:
a. On the Analog Router Name line, select the router from which analog
sources will be routed to the ImagePRO (or PrePRO-II).
b. On the Analog Router Output line, select the specific router output that
you designated as an Aux output.
c. On the ImagePRO Input (or PrePRO-II Input ) line, select the
ImagePRO or PrePRO-II input to which the analog router output is
connected.
10. In the SDI section:
a. On the SDI Router Name line, select the router from which SDI sources
will be routed to the ImagePRO (or PrePRO-II).
b. On the SDI Router Output line, select the specific router output that you
designated as an Aux output.
c. On the ImagePRO Input (or PrePRO-II Input ) line, select the
ImagePRO or PrePRO-II input to which the SDI router output is
connected.
11. In the DVI section (applies to ImagePRO Aux destinations only):
a. On the DVI Router Name line, select the router from which DVI sources
will be routed to the ImagePRO.
b. On the DVI Router Output line, select the specific router output that you
designated as an Aux output.
c. On the ImagePRO Input line, select the ImagePRO input to which the
DVI router output is connected.
12. Press
{
BACK
}
to return to the Destination Setup Menu .
13. Repeat from step 4 to configure another ImagePRO or PrePRO -II Aux
destination.
14. Press
{
BACK
}
to return to the System Menu .
15. Press
{
HOME
}
to return to the Home Menu .
16. Press
{
SAVE
}
to save the new system configuration in memory.
This completes the procedure for defining ImagePRO or PrePRO -II Aux destinations. The
selected button(s) on the Destination Bus are now active. Please note:
•
For proper operation, ImagePRO and PrePRO-II devices must be connected to
the ScreenPRO-II Controller via Ethernet.
•
ImagePRO and PrePRO-II output setups must be performed locally on the units
themselves.
•
Only one router of each type (Analog, DVI and SDI) can be connected to an
ImagePRO unit.