Barco ScreenPRO-II, Руководство пользователя

Страница: 199 / 292

ScreenPRO-II Controller • User’s Guide 199
5. System Setup
Output Format Setup
6. If you selected an individual ScreenPRO-II ID or ALL SP , on the ScreenPRO-II
Input line, select the specific input connector on the ScreenPRO-II.
7. On the Tally Number line, select the tally that you want to associate with the
source button.
8. Press { ADD PATCH } to confirm your changes.
9. Repeat the procedure from step 3 to patch additional Controller buttons.
10. (Optional) If required, press
{
DELETE PATCH
}
to clear all registers for a selected
Controller input. This enables you to start again with an “undefined” patch.
11. Press
{
BACK
}
to return to the System Menu .
12. Press
{
HOME
}
to return to the Home Menu .
13. Press
{
SAVE
}
to save the new system configuration in memory.
lìíéìí=cçêã~í=pÉíìé
ScreenPRO-II Controller system setup: Step 11
S
Prerequisites — Ensure that you are familiar with the Output Menu . In
Chapter 4, refer to the “ Output Menu Functions ” section on page 102.
In this procedure, you will configure the output format for each ScreenPRO-II that is used in
your ScreenPRO-II Controller system.
„
Use the following steps to set up the ScreenPRO-II output format:
1. From the Home Menu , press OUTPUT to display the Output Menu .
2. On the Destination Bus , select the destination that you want to configure.
3. On the Format line, select the resolution and frame rate at which you want to
drive the destination’s projector(s). To minimize synchronization problems, select
a frame rate that is consistent with your input sources.
4. Press
{
APPLY FORMAT
}
to accept the selection.
5. Repeat from step 2 to set additional destination output formats.
6. Press
{
HOME
}
to return to the Home Menu .
7. Press
{
SAVE
}
to save the new system configuration in memory.
Important If you elect to use tallies, the optional Tally board must be
installed, and relay connections must be run to the devices
that you wish to tally. In Appendix A, refer to the “
Tally
Connector ” section on page 262 for connector pinouts.
11
Important Be sure to select your projector’s native resolution and a
frame rate that is consistent with your inputs — for example, if
you are using 59.94 NTSC video inputs, run the output at the
same rate in order to be synchronous.