Barco ScreenPRO-II, Руководство пользователя

Страница: 187 / 292

ScreenPRO-II Controller • User’s Guide 187
5. System Setup
System Power Up
póëíÉã=mçïÉê=ré=
ScreenPRO-II Controller system setup: Step 2 .
In this procedure, you will power up the entire system, and download code (if required).
„
Use the following steps to power up your ScreenPRO-II Controller system:
1. Ensure that all individual ScreenPRO-II units are powered up.
2. Power up all routers in your system, and allows them to fully boot up. These are
your devices with static IP addresses.
3. Power up the ScreenPRO-II Controller, and allow it to fully boot up. This is the
system’s DHCP server.
4. If you will be using a widescreen configuration, power up the BlendPRO-II.
5. Power up all PresentationPRO-II units and ImagePRO units in your system. This
sequence enables the ScreenPRO-II Controller to “serve” IP addresses to the
other peripherals.
6. Power up all additional peripherals, such as monitors and projectors.
7. Check the ScreenPRO-II Controller’s Status Menu , and ensure that all devices
have been recognized. By default, this menu should appear at power up. If it is
not shown, press
STATUS on the Home Menu .
8. Check code compatibility — when the ScreenPRO-II Controller connects to the
individual devices, it automatically checks the compatibility of the code versions.
~
If the Controller’s code version matches that of the ScreenPRO-II units,
PresentationPRO-II units and BlendPRO-II, the
Status Menu is shown
— and you do not need to download code.
~
If the message “ Checksum Mismatch ” appears on the Status Menu ,
you must download code. Please continue with the “ Downloading
Code ” procedure on page 188.
~
If the Controller’s code version is incompatible with the code version of a
ScreenPRO-II, PresentationPRO-II or BlendPRO-II (or a combination of
units), all buttons will flash on the Controller console. The
Status Menu
is shown with the message “ Please Upgrade .” Please continue with the
“ Downloading Code ” procedure on page 188.
2