![background image](http://html1.mh-extra.com/html/barco/fsn-series/fsn-series_user-manual_3894029302.webp)
302
FSN Series • User’s Guide
8. Updating Software
Software Update Overview
pçÑíï~êÉ=réÇ~íÉ=lîÉêîáÉï
Firmware files for the FSN-1400 and control panel are loaded into the hardware at power-
up. These files are stored in the unit’s onboard flash memory. Two different update
procedures can be performed:
•
Update FSN-1400
and
Control Panel
— This procedure updates both the control
panel and the FSN-1400. A “new” software update file is required.
•
Update FSN-1400 only
— This procedure updates the FSN-1400 software to
match the control panel software. Use this procedure if the label “
Mismatch
”
appears in the
System Status Table
on the
System Menu
.
For a “new” software update, following is an overview of the steps required:
1.
Verify your hardware. Refer to the “
” section below.
2.
Download the appropriate “update” file. Refer to the “
”
section on page 303.
3.
Transfer the software to a USB thumb drive.
4.
Insert the USB drive into the control panel’s top USB port.
5.
In the
Navigation Bar
, press
{System}
to display the
System Menu
.
6.
Press
{Software}
to display the
Software Menu
.
7.
To update the control panel, refer to the “
Updating Control Panel Software
”
section on page 305.
8.
To update the FSN-1400, refer to the “
” section on
e~êÇï~êÉ=oÉèìáêÉãÉåíë
The following hardware items are required for upgrading FSN Series software:
•
IBM compatible computer with an available Ethernet port and USB port.
•
USB thumb drive, minimum 1 GB.
•
Internet connection.