FSN Series • User’s Guide
251
6. System Setup
Clean Feed Setup
`äÉ~å=cÉÉÇ=pÉíìé
FSN Series system setup:
Step 8
In this procedure, you can set clean feed outputs, and select a source for the
ASSIGN
button (in the control panel’s
Aux Section
).
S
Prerequisite
— Ensure that you are familiar with the
Clean Feed Setup
Menu
. In Chapter 5, refer to the “
” section on
Use the following steps to set clean feed outputs:
1.
In the
Menu Bar
, press
{System}
to access the
System Menu
.
2.
Press
{Clean Feed Setup}
to display the
Clean Feed Setup Menu
.
3.
Press
{Clean Feed Outputs}
to display the
Clean Feed Outputs Chart
.
4.
On the chart, select the desired clean feed point for M/E 1’s clean feed output:
~
Press
{M/E 1 Clean 1}
to select the point prior to Keyer 1.
~
Press
{M/E 1 Clean 2}
to select the point prior to Keyer 2.
~
Press
{M/E 1 Out}
to select the point after Keyer 2.
5.
Select the desired clean feed point for the PGM bank’s clean feed output:
~
Press
{PGM Clean}
to select the point prior to the DSK.
~
Press
{PGM Out}
to select the point after the DSK.
Use the following steps to select the clean feed source that is mapped to the
ASSIGN
button in the control panel’s
Aux Section
:
6.
Press
{Assign Button}
to display the
Assign
Button
Chart
.
7.
Select one of three mutually exclusive clean feed points for the button:
~
Press
{M/E 1 Clean 1}
to select the point prior to Keyer 1.
~
Press
{M/E 1 Clean 2}
to select the point prior to Keyer 2.
~
Press
{PGM Clean}
to select the point prior to the DSK.
Please note:
•
The clean feed selection is
global
for all Aux routes. If you change the mapping
for one route, it changes for
all
routes.
•
To quickly display the
Assign Button Tab
, press and hold the
ASSIGN
button.
8
