256
FSN Series • User’s Guide
6. System Setup
Universal Input Setup
24.
Use the
{Mask Top}
,
{Mask Bottom}
,
{Mask Left}
and
{Mask Right}
controls to
mask selected portions of the image, as required.
25.
Select the method by which you want to size and scale the image. Masked edges
are taken into account.
~
Press
{Fill H}
to scale the selected universal input up (or down) to the
current native
horizontal
resolution. Aspect ratio is maintained.
~
Press
{Fill V}
to scale the input up (or down) to the current native
vertical
resolution. Aspect ratio is maintained.
~
Press
{Fill H/V}
to scale the input up (or down) to the current native
horizontal
and
vertical
resolutions. Aspect ratio is not maintained.
26.
If required, press
{Reset Fill}
to return the input to its previous scaling. Mask
settings are retained.
27.
If required, press
{Clear Mask}
to return all mask settings to 0 (zero). Scaling is
maintained.
28.
Press
{Reset All}
to return the input to its previous scaling, and return all mask
settings to 0 (zero).
Use the following steps to set up universal input color correction:
29.
To adjust the selected input’s overall brightness and contrast, press
{Brightness
Contrast}
. Use the
{Brightness}
and
{Contrast}
controls as desired.
30.
To adjust the input’s RGB brightness, press
{RGB Brightness}
. Use the
{Red
Brightness}
,
{Green Brightness}
and
{Blue Brightness}
controls as desired.
31.
To adjust the input’s RGB contrast, press
{RGB Contrast}
. Use the
{Red
Contrast}
,
{Green Contrast}
and
{Blue Contrast}
controls as desired.
32.
To adjust hue and color saturation, press
{Hue Sat}
. Use the
{Hue}
and
{Sat}
controls as desired.
Use the following steps to save input settings:
33.
Press
{Save Settings}
to save the selected input’s setup parameters.
34.
Press
{Back}
to return to the
Input Menu
.
35.
Repeat from step
3
for each additional input that you wish to set up.
Important
Because you can install either a
NIC
or a
UIC
in slots
3
and
4
,
If you move or change card assignments in these two slots
during setup, the setup is invalidated, and must be repeated
once the final card configuration is reached.
