B&R Power Panel C80, Руководство пользователя

Страница: 32 / 74

Device description
Variant with 1x CAN bus and 1x RS232
LED Color Status Description Interface
OPS1 - - Reserved. -
OPS2 Yellow On TxD/RxD: Data is being transmitted or received.
Off Terminating resistor not switched on. OPS3 Yellow
On Terminating resistor switched on.
IF7: CAN bus
OPS4 Yellow On TxD/RxD: Data is being transmitted or received. IF9: RS232
OPS5 - - Reserved -
Variant with 1x CAN bus and 1x RS485
LED Color Status Description Interface
OPS1 - - Reserved. -
OPS2 Yellow On TxD/RxD: Data is being transmitted or received.
Off Terminating resistor not switched on. OPS3 Yellow
On Terminating resistor switched on.
IF7: CAN bus
OPS4 Yellow On TxD/RxD: Data is being transmitted or received.
Off Terminating resistor not switched on. OPS5 Yellow
On Terminating resistor switched on.
IF10: RS485
4.7.6 Fieldbus interfaces
Pinout
Figure
Terminal Description
X2X Link
1 X2X X2X data
2 SHLD Shield
3 X2X\ X2X data inverted
4 X2X⊥ X2X ground
CAN bus
5 CAN_H CAN High
6 CAN_L CAN Low
7 GND Ground
CAN bus
8 GND Ground
9 CAN_L CAN Low
10 CAN_H CAN High
RS232
8 GND Ground
9 RxD Receive signal
10 TxD Transmit signal
RS485
8 GND Ground
9 DATA\ Data inverted
10 DATA Data
Required accessories
0TB5104.2110-01 Accessory terminal block, 10-pin (3.5), cage clamp terminal block, 1.5 mm²
Interface Maximum transfer length
X2X Link 100 m between 2 nodes (segment length)
Bus length up to 25 m: 1 Mbit/s
Bus length up to 60 m: 500 kbit/s
Bus length up to 200 m: 250 kbit/s
CAN
Bus length up to 1000 m: 50 kbit/s
RS232 115.2 kbit/s
RS485 115.2 kbit/s
4.7.7 Reset button
The device is set to mode SERVICE mode with the reset button by default. This setting can be changed in Au-
tomation Studio.
32 Power Panel C80 User's manual V1.02