Bandit 200UC, Инструкция по эксплуатации и каталог запасных частей

Страница: 38 / 110

24 1/21
MODEL 200 UC TRANSPORTATION PROCEDURES
OPTIONAL SLIDING TONGUE
The optional sliding tongue is used when the chipper’s tongue is not long enough to hook to the
machine to a tow vehicle and have proper clearance when turning or backing up the machine.
1. Before attempting any type of maintenance,
disengage clutch, wait for the disc to
come to a complete stop, turn off engine,
remove the ignition key, make sure the
ignition key is in your possession, install the
disc lock pin, and disconnect the battery.
2. Remove the two 5/8” bolts and hardware from
the side of the sliding tongue.
3. Pull the sliding tongue out approximately 20”
until the next set of holes in the sliding tongue
are aligned with the stationary tongue tube.
If the sliding tongue does not need to be extended
for the towing vehicle, depending on hitch type and
placement, reverse the procedure above and retract
the tongue back to the non extended tongue length.
Remove and
reinstall these
bolts
4. Reinstall the two 5/8” bolts and hardware. Two
bolts must be used to pin the sliding tongue.
5. Tighten both sliding tongue bolts and automated
lock nuts until they are snugged up to the
tongue bushings, but still able to spin inside
the bushings. If the bolts will not fi t through the
holes, an 11/16” or 21/32” drill bit can be used
to remove debris from the hole.
6. Follow all transportation procedures to hook the
machine to a tow vehicle and transporting it.
NOTICE