68
Maintenance and service
18 2 1 Cleaning the transmitter and receiver
Before cleaning, you must turn off the ignition on the vehicle
and take out all the plugs of the wireless control unit so that no
function is triggered accidentally. Clean the system parts with a
damp or soaked in spirits cloth.
NOTICE!
Risk of damage to the device from cleaning the vehicle
Prevent system parts having direct contact with oils or
lubricants. The system parts may not be cleaned with a
steam-jet degreaser / high-pressure washer.
18 2 2 Transmitter batteries
To prevent a deep discharge, the transmitter automatically
switches itself off when there is very low battery voltage
(passive emergency = OFF).
Charge the batteries regularly.
If the status LED of the transmitter goes out just a short time
after the transmitter is switched on, the batteries must be
replaced (see commissioning / preparation / installing the
transmitter batteries).
In the event of an emergency, a work process that has begun
can be ended by switching on the transmitter again.
18 2 3 Fuse replacement on receiver F10 E
NOTICE!
Risk of damage to the device from opening the receiver
housing
The receiver may only be opened by qualified specialist
personnel. In general do not interfere with the device as
this will invalidate the warranty.
Si 5
Si 4
Si 3
Si 1
K5 K6 K7 K8 K9 K10 K11
K1 K2 K3 K4
K12 K13
Position of the fuses and relay in receiver F10 E
