52
Operation
Requirements for safe operation
Wear protective work clothing suitable for the activity and
the deployment location (PPA).
Before switching on the wireless control, ensure that nobo-
dy could be put at risk from operation.
Always work with a direct line of sight to the machine and
proceed with particular caution if you are not yet familiar
with operating the wireless control.
Ensure that you do not accidentally mix up the cable mo-
vement directions when changing locations or confuse the
two sides when using double-drum winches.
To ensure that a work phase ends and consequently safe
conditions can be established on site in the highly unlikely
event of total failure of the battery, it is recommended that
you always carry two spare batteries and the manual con-
trol for the winch with you in the vehicle.
The stop and emergency call switch on the transmitter
only affects the winch and is not to be confused with the
machine's emergency-off.
Any non-observance of the safety information may result in
serious accidents and injuries.
In addition to generally applicable regulations for accident
prevention, the local regulations should also be observed.
Follow the instructions in the section "Maintenance".
Only use the wireless control within the climatic, environ-
mental conditions that are specified in the section "Techni-
cal data".
17 2 F10 E receiver
Diagnostics LED
F10 E receiver activation
Switch the vehicle ignition on and start the vehicle.
Switch the receiver on with the ON/OFF switch.
The diagnostics LED on the receiver flashes red.
Check whether the waist or chest belt is damaged each
time before starting work to prevent the loss of the trans-
mitter.
