48
Commissioning
16 Commissioning
16 1 Requirements
The correct cabling of the receiver to the winch or to the
vehicle has been performed by a specialist according to
the relevant pin assignment diagram.
The transmitter battery is charged.
16 2 Preparation
16 2 1 Receiver connection
Insert the connection plug(s) of the receiver into the
socket(s) provided on the winch / the vehicle.
DANGER!
Danger from incorrectly connected control unit
Do not insert the connection plug of the receiver into an
incorrect socket (e.g. vehicle socket for trailers). If two
separate connection sockets for connecting the manu-
al control and the wireless control are located on the
winch,
only one control unit may be
connected at any
one time. When using the wireless control, ensure that
the manual control cable is pulled out
.
16 2 2 Transmitter battery installation
Groove for guide tab
Groove for guide tab
Guide tab
Transmitter battery installation
Turn the screw cap of the battery compartment in a coun-
terclockwise direction and pull the cap off. Use a coin to
help you if necessary.
Insert the left battery according to the correct polarity
(negative pole upwards).
Insert the right battery according to the correct polarity
(positive pole upwards).
Feed the guide tabs of the screw cap (positioned to be
rotated) into the grooves of the transmitter housing.
Turn the screw cap of the battery compartment back on
tightly in a clockwise direction.
