Baldor VS1SM, Инструкция по установке и эксплуатации

Страница: 42 / 71

7-14 Parameter Descriptions MN761
7.3 Function Group2
Continued
Parameter # Access Parameter Name, Value Range, Description and Preset Value
RW Load Inertia Rate (Range:
0- Load inertia rate is less than 10 times that of motor inertia
1- Load inertia rate is approximately 10 times the motor inertia.
2- Load inertia rate is more than 10 times that of motor inertia.)
Sets the load inertia rate.
Preset Value:
0
RW PWM Frequency (Range: 1-15kHz)
Sets the PWM for the PWM output.
Preset Value:
3
RW Control Mode (Range:
0- Volts/Frequency
1- Slip Compensation
2- PID Feedback
3- Sensorless Vector )
Sets the control mode for the drive
Preset Value:
0
RW Auto Tuning (Range:
0- Off. Auto tune will not.
1- On. Parameters H42 and H44 are automatically measured and adjusted.
Specifies whether or not H42 and H44 will be measured automatically.
Preset Value:
0
RW Stator Resistance (Range: 0-14ohms)
Sets the stator resistance value of the motor. If H41=1 this value is
measured and automatically adjusted.
Preset Value: CALC
RW Leakage Inductance (Range: 0-300.0mH)
Sets the leakage inductance value of the stator and rotor of the motor.
If H41=1 this value is measured and automatically adjusted.
Preset Value:
RW Sensorless P Gain (Range: 0-32767)
Sets the P Gain for Sensorless Vector Control of the motor.
Preset Value:
1000 Parameter is only displayed when H40=2 or 3.
RW Sensorless I Gain (Range: 0-32767)
Set the I Gain for the motor during Sensorless Vector Control.
Preset Value:
100 Parameter is only displayed when H40=2 or 3.
RW PID Feedback (Range:
0- Terminal I Input (0-20 mA)
1- Terminal V1 Input (0-10V))
Sets the feedback type of PID controller.
Preset Value:
0 Parameter is only displayed when H40=2 or 3.