Azbil MagneW Two-wire PLUS+ MTG15A, Руководство пользователя

Страница: 256 / 280

7-30
Pulse output adjustment
To adjust the pulse output, proceed as follows:
1. From online menu,
Select:
1. Device setup

2. Diag/Service

3. Calibration

5. Pulse trim
Fig. 7-62. will then be displayed.
If the control system is not affected by the
forcible change of the current signal, press
F4 (OK). By pressing F3 (ABORT), the
procedure is canceled.
OK EXIT ENTER ESC ABORT DEL SAVE HOME HELP
MAGNEW2W: ** ******
Choose EX trim func
1 Set
2 End
Fig. 7-62.
2. Fig. 7-63. will then appears. Connect the
device to measure the pulse output, and
then press F4 (OK).
OK EXIT ENTER ESC ABORT DEL SAVE HOME HELP
MAGNEW2W: ** ******
Set meter digit
0.0000 mV
35.5
Fig. 7-63.
3. Fig. 7-64. will then appear. By pressing F4
(OK), the pulse output adjustment will
start and the converter will output a pulse
of 90 Hz. If it is fine, press F4 (OK).
Fig. 7-64.
4. Fig. 7-65. will then appear. When
executing the adjustment, select “SET”,
and then press F4 (ENTER).
OK EXIT ENTER ESC ABORT DEL SAVE HOME HELP
MAGNEW2W: ** ******
Chose output check
analog current
1 Start
2 Exit
Fig. 7-65.
5. A numerical value input display (Fig.
7-66.) will then appear.
Measure the pulse frequency from the
converter and enter the frequency by the
Hz into the device. Once the input has
been completed press F4 (ENTER). The
converter will start adjusting to 90 Hz
automatically, and return back to the
display as shown in Fig. 7-65. Verify that
the pulse output is 90Hz, and terminate
the adjustment.
OK EXIT ENTER ESC ABORT DEL SAVE HOME HELP
MAGNEW2W: ** ******
NOTE-Loop may be
returned to automatic
Control
Fig. 7-66.