Phone Based Administration
Page 204
- Issue 6a (Thursday, February 22, 2018)
IP Office Basic Edition
Comments on this document? [email protected]
·
To exit phone based administration at any time, press the
Release
button. To select a different process use the
Next Procedure
or
Previous Procedure
buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. Do one of the following depending on whether you want to change the button programming of the extension you
are using or that of another extension.
To program the same extension
To program another extension
a. At the phone, press
Feature 00
.
b.
Program Extension:
is shown on the
display.
a. At either of the first two extensions on the system, press
Feature
00
followed by two presses the first intercom or call appearance
button and one press of the second intercom or call appearance
button.
Centralized Programming:
is shown on the display.
b. At the
Extension:
prompt enter the number of the extension.
2. To select the button, press the corresponding button. For buttons up to 99, you can also dial the button number.
The current setting of that button is displayed.
6. Enter the number of the extension to be programmed.
7. At the
Button:
prompt enter from 03 to 99 to select the line button for which you want to view the line ringing
setting.
8. The display will show
LINE RINGING:
and the current ring setting for the line on that button and the line number it
represents in the form
<ring setting>
-L
<line number>
.
·
I-
= Immediate ring,
D-
= Delayed ring (5 seconds delay),
N-
= No ring.
8. To change the setting from its current value enter the button number again.
9. To view the setting of another line button enter the number of that button.
·
Exit programming by pressing
Feature 00
. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.