67
XXXX ‘5’ - Toggled chime mode (only if all partitions are OFF)
MMMM ‘6’ - Display ‘Follow Me’ phone number
MMMM ‘6’+’6’ - Erase ‘Follow Me’ phone number
MMMM ‘6’+’6’+PPPP - Program ‘Follow-Me’ number (PPPP = follow me number)
MMMM ‘6’+’6’+’7’ - Dialer test
MMMM ‘7’ - Enter Fault Find mode (command is acknowledged only during the first 15 seconds
after the system was disarmed)
MMMM ‘8’ - Enter user codes for program mode. Default programming code is 1234.
DDDD ‘8’ - Enter Dealer code (Installer) programming mode. Default code is 1994.
MMMM ‘9’ - Stops dialer test, clears the phone fault ('C') indication.
XXXX ‘9’ - Stops buzzer and resets ‘day’ troubles in partition. Activates the output used for fire
detectors reset.
Programming notes
Addresses 533 through 547: User's partition.
These addresses contain the partition associated to a user.
Enter a two-digit number in the range 01 - 08 in these locations.
Note:
No matter what value is entered for user 01, it will always be considered as set to 1.
Programming partitions: Addresses 500 through 531.
By default, 16 zones allocated to partition 01.
A zone cannot be part of two or more partitions. Therefore, even if zones are programmed in
several partitions, after exiting programming mode the system ‘re-orders’ zones and keep them in
the lowest numbered partition. For example, if a zone programmed in partition 2 and 4, it is erased
from partition 4.
For this reason it is recommended to erase zones from lower partitions if they are to be
programmed in higher partitions. As a start, clean all locations for partition 1, then program zones
in other partitions.
All the ‘orphan’ zones (those that had not been programmed somewhere) automatically added to
partition 1 (the system does its ‘book keeping’ after programming mode is exited).
