21
•
For Arming/Disarming via Wireless Radio Remote, connect receiver's relay to ‘KE’ and
‘- Aux. Power’ terminals. Verify the receiver relay mode, momentary, or latch, and set
system accordingly.
4.8
Remote Access via DTMF
General Description
Remote DTMF enables remote control of the alarm panel from a DTMF phone, this unique
feature provides Home Automation function and other functions as detailed below.
DTMF commands are possible when the panel call your phone, or by calling the panel. The
DTMF remote control functions:
Î
Check the status of the control panel (Armed/Disarm, Alarm in progress)
Î
Arm or disarm the control panel
Î
Bypass zones or clear all bypassed zones
Î
Stop the dialer report during alarm
Î
Momentary activate A1 (alarm) output for three seconds
Î
First Alarm indication - by a number of beeps per zone, special tune for Panic alarm
The same options are available when a call received from the control panel during an alarm
condition.
To enable the DTMF control program address 076/4 “Enable remote access by telephone”, and
076 - 2 “Enable A1 activation by telephone”.
In AV-2016DP, only User 01 (master) is allowed to Arm, Disarm and Bypass zones, all other
functions are accessible to all users.
Keypad online conformation and DTMF functions history
When the control panel detects the first DTMF key, five short beeps at the keypads. The keypad
activation shows the user at the remote site that a DTMF connection takes place (in case of
mistaken connection or similar).
During the remote access the keypad display 'd' and all LEDs blink fast from time to time.
At call ends, three short beeps sound at the keypads. When the user code is in process, the
keypad display shows a line for each code number entry (disclose the code), then each DTMF
number pressed show the received number.
History log: Each call, confirmed by a valid user code, Arming/Disarming and other events
made by the remote DTMF phone are recorded in the event history.
"Last users" history will display 'ut' for "
u
ser "
t
elephone, followed by the User number.
Notes: 1. The keypad buzzer or other loud sounds may jam your DTMF entries, in case the
keypad is close to your DTMF telephone, during testing disable the buzzer.
2. When entering the DTMF commands wait for “quit” period, if entering commands
during the system confirmation tunes, or other tunes the panel may miss the DTMF
entries.
The panel calls the user during alarm
When the control panel calls the user during alarm, it will first generate the siren sound for
about 30 seconds (to shorten this feature at address 085
“
Tel. Message Time
”
, to 30, as default
