AV-GAD EasyLoader AV-2016D, Инструкция по установке и эксплуатации

Страница: 35 / 76

35
1.1 ˆ User Code Programming via AV-701 Keypad (Not with AV-2016DP)
Set New USER-CODE
1. Hold down key
8
Program
2. While the four LEDs are blinking, enter code No. 1 (default 1 2 3 4)
3. If code is valid, the four LEDs stop blinking, and ‘u’ displayed
4. The 2 left-most LEDs blink to indicate that the system is waiting for a new user code index
(user 1 to 16) to be entered
5. Enter the code index (01 for code No. 1; 02 for code No. 2, etc.)
6. The 2 right-most LEDs blink to indicate that the system is waiting for a new code (1 to 6 digits)
to be entered.
The code voided if user code not entered.
7. Enter the new code; ‘U’ is displayed for confirmation.
8. To quit code setting hold-down key ‘9’.
Set new USER-CODE in Installer program mode
1. While system is in program mode, enter address 099, ‘u’ will be displayed
2. The two left-most LEDs blink to indicate that the system is waiting for a new user code index
(user 01 to 16) to be entered. User index displayed for 2 seconds, until user can press and enter
further digits (eliminate confusing of index number and code)
3. The two right-most LEDs blink to indicate that the system is waiting for a new code (1 to 6
digits) to be entered. Enter the new code.
4. Installer Code (code no. 17) can only be set at Program mode. Installer Code index number is ‘17’.
5. Upon completion of code setting, system reverts to Disarm mode.
Delete a USER-CODE
1. Hold down key
8
Program
2. While four LEDs are blinking, enter code No. 1 (default 1 2 3 4)
3. If code is valid, four LEDs will stop blinking and ‘u’ display
4. The two left-most LEDs blink to indicate that the system is waiting for a new user code-index
(01 to 16) to be entered.
5. Enter the code index you want to delete (1 for code No. 1; 2 for code No. 2, etc.)
6. The two right-most LEDs blink to indicate that the system is waiting for a new code.
If not entering a user code, the code voided. A short sounder beep confirms that code
deleted
7. It is now possible to enter a new code; ‘U’ displayed for confirmation.
8. To quit code setting Hold-down key ‘9’.
Instant Arming by key number 5
Chime
is a programmable feature, which may cause erroneous
Arming. It is recommended to disable this feature . Do not to use 5 or 0 as the 1st digit of the code