27
2.
0
Shunt
and
0
Shunt
Detailed Events History (requires programming):
Hold down key
‘0’ and again hold down key ‘0’ to display up to 36 events, including: System opening and
closing by user number, opening or closing time, alarming zone and AC fail.
By holding-down key
0
Shunt
twice, three LEDs start blinking, to indicate a special operation
mode. The events are displayed from the most recent event to the oldest.
At AV-701/2 keypad the events displayed as following:
XX - Event number (from 01 to 36), then HH_MM (Hour and Minutes) Event Time, Event
(alarm or opening/closing).
Translate the display as following:
‘u’ (user number 1 to 16), ‘o’ or ‘c’ - opening or closing, Zone causing alarm will blink twice
tX - Tamper alarm from zone causing the alarm (X), H - Panic Keypad Alarm
Note:
3 lines (
≡
) indicate power fail. An AC fail event displayed during history events.
Event
AV-701, 702 display
Time set
'tu'
Date set
'du'
Installer programming
'IP'
User programming
'UP'
Factory defaults
'Fd'
Communication (to CS) failure 'CF'
Panic from Panic zone
‘Hzz’ (zz = zone number)
Keypad locked (code error)
'PE'
Low Battery
'Lb'
Table 1: Events as displayed at AV-2016D
Events display example at AV-701, 702:
01 2 2 _ 2 4 u 1 o 02 2 3 _ 0 5 7 7 03 2 3 _ 3 5 H H 04 0 0 _ 0 8 u 1 c -
- Sign then long beep
Event 01
Time
User 1
Opening
Event 2 Time Alarm Zone 7 Event 3 Time Alarm Zone H Event 4 Time User 1 Closing
Display
indicates end of History
Zone no. blinks twice
Figure 8: Events Log as Displayed at Keypad
During zone number display, keypad display blinks twice to indicate the zone number.
Browsing through Events History
Keys used for browsing:
2
Shunt
Display
¾
Skip forward to next event
5
Chime
¾
Display current event again
8
Program
¾
Skip backward to previous event
9
Reset
¾
Cancel History Event Mode and exit
