32
t
Tamper
Indicates zone's Tamper alarm
U
Update
Confirms programming updating
u
User
‘u’ (user) followed by user number when events log is
displayed and system is in user code programming
mode
≡
Arming Denied
or
AC Fail
≡
displayed upon Arming attempt with non-delayed
(instant) zones in trouble.
≡
displayed upon and after AC fail while system is
Armed or Disarmed
1.6
Arm and Disarm System via AV-701/702 Series Keypad
1. Make sure that all burglary zones are closed.
2. The green Status LED indicator will remain lit (not blinking) while all zones are closed.
3. Green indicator will blink when a zone is troubled. Press key 3 for display of troubled zone
on keypad. An open delayed zone (exit zone) will also cause indicator to blink.
≡
(3 lines) indicated at arming of system if instant zones or 24-Hour zones are troubled
(blinking Green LED indicator followed by
≡
in display and 5 warning beeps); open zones
will then be displayed.
4. To bypass a zone, press key 0 (Bypass Key), followed by the zone number.
To bypass a pre-programmed group of zones (requires programming), press 0 (zero key)
twice (short press). AV-2016DP/2.09: Enter your code then press key 3.
5. Arming: Enter the Arm/Disarm code (No. 1 default code is 1,2,3,4), the Red Armed
indicator will light up. If any zone (not Delayed or Follower) is troubled,
≡
will be displayed
and system will remain Disarmed.
System Arming is disabled if Instant zone troubled.
6. For Instant Arming, press key 5 (if previously programmed). See address 071.
Red ‘Armed’ indicator should light up. The system is now armed.
7. Disarming: you may have to hold-down key 9 (reset) to clear any previous key presses, and
then enter arm/disarm code (or turn optional key-switch); the Red ‘Armed’ indicator will go
off.
Alarm history displayed upon disarming. If a 24H alarm occurs during Disarm mode Enter
Arm/Disarm code.
8.
Keypad Keys Self Locking:
In Armed and Disarmed mode, after six attempts to enter fault
code, the keys will not react to any key press. This prevents code learning or other code
break exigency. After a 30 seconds delay, the keys will revert to code entry mode. Each new
erroneous code will lock system for another 30 seconds.
9.
Auto Arming
Programming the time for Automatic Arming:
- By Installer
: Program (or display) the hours and minutes at address 016.
- By User
: Enter to user programming mode. Hold down '8' ('A' is displayed); type hour and
minutes in 24 hours format. To display, hold down '8' and wait. To disable Automatic
Arming program 0000.
