57
3. Enter the required telephone numbers (maximum 16 digits) at address 010 to 013. For
example program Tel. 1 to be 00972-36816767; Press 010, the two left LED's blink, enter the
number 00972 in sequence, hold-down ‘0’ (pause), enter 36816767; wait for ‘u’ confirmation.
To insert * in the telephone number; Hold-down keys # and * (panic); * will be displayed as
‘A.’ (* is valid during dialing in DTMF mode).
For Dialing Pause hold-down key ‘0.’ Note: Two pauses (one following the other, or a pause
at the end of the telephone number) are not valid. Maximum 4 pauses per Tel. number.
4. To quit the programming mode Hold-Down key ‘9’.
2.9.1
Deleting Telephone Numbers
1. Enter program mode, confirmed by ‘P’ in display.
2. Press 010 (address 010) for telephone No. 1. At 3 LEDs blinking, hold-down key ‘9.’
3. Follow same procedure for the telephone requiring deletion.
2.9.2
User Programming of ‘Follow-Me’ Telephone Number
To program the Follow-Me number, disarm the system (‘USE’ mode).
1. Hold down key [6] twice, wait for the blinking of 3 LEDs.
2. Enter Telephone Number (maximum 16 digits and 4 pauses), and wait until all LEDs stop
blinking. The ‘Follow-Me’ number programmed.
3. To delete ‘Follow-Me’ number, access ‘Follow-Me’ programming mode as described in
paragraph 1, but do not enter any digits.
To program the system to automatically erase ‘Follow-Me’ number after Disarm, see Address
071 on Programming Sheet.
2.10
Quitting Programming Mode
Upon completion of programming, Hold-Down key 9.
2.11
Verification of Current Programming
(Programmed
Values)
Enter to Program Mode by holding down key
8
Program
and enter programming code. ‘P’ is
displayed.
Enter address to be verified. The value of that address will be briefly displayed and three LEDs
will blink.
Wait until LEDs stop blinking before verifying next address.
Upon completion, you may disconnect all power.
All programming will remain intact during System power-up.
