Autonics PMC-1 HS, Руководство пользователя

Страница: 5 / 82

2
© Copyright Reserved Autonics Co., Ltd.
Cautions during Use
1. Follow instructions in 'Cautions during Use'.
Otherwise, It may cause unexpected accidents.
2. 24VDC power supply should be insulated and limited voltage/current or Class 2, SELV power supply device.
3. Install a power switch or circuit breaker in the easily accessible place for supplying or disconnecting the
power.
4. Wire as short as possible and keep away from high voltage lines or power lines, to prevent inductive noise.
5. Run the unit after proper parameter settings depending on the load and environment.
6. Make sure that Power On function is set to ON in atMotion program before supplying the power to the unit.
7. Keep the distance between power cable and signal cable more than 10cm.
8. It is recommended to use twisted pair shield wire when connecting cables to CN3, 4, 5 connectors.
Ground the shield wires depending on the installation environment.
9. It is recommended to use the communication cables provided with the product. (RS232C, USB)
10. When wiring the RS485 cable, twist pair wire is recommanded, and use AWG 24 (0.2mm
2
) cable or over.
11. This unit may be used in the following environments.
①
Indoors (in the environment condition rated in 'Specifications')
②
Altitude max. 2,000m
③
Pollution degree 2
④
Installation category II
※
The above specifications are subject to change and some models may be discontinued without notice.
※
Be sure to follow cautions written in the instruction manual and the technical descriptions
(catalog, homepage).