●
The type of seating at the bar chart (right), with the letters L (Limit) = limit
seating and T (Torque) = torque seating. At 0 % for end position CLOSED and
at 100 for end position OPEN.
Operation commands (S0003)
Figure 65:
After approx. 3 seconds
without operating the selector switch/shuttle dial, the
navigation line is masked at the bottom of the display.
The display
S0003
shows the following information on operation commands:
●
The applied torque M as bar chart (left) and as figure
Standard unit = Nm, selection available between ft-lb and % via menu
Torque
unit M0051
.
●
Valve position or actual value E2 between 0 – 100 % of travel as bar chart
(right) or as figure in the middle.
For setpoint control (if positioner is enabled and activated), the setpoint position
E1 is displayed, or-N/A-.
●
Operation direction indication: The direction of the active or the last operation
command is indicated by an arrow next to the bar chart:
= Operation command OPEN;
= Operation command CLOSE
●
Pivot points (intermediate positions) by arrows to the right of the valve position
bar chart:
53
TR-M30X – TR-M1000X
TR-MR30X – TR-MR1000X
Indications
