Athena 1470-HE EVO, Перевод оригинальной инструкции

Страница: 102 / 196

PAGE
102
It is forbidden to travel above the transport height in the following conditions:
•
Wet ground
•
Snowy and/or icy ground
•
Dry asphalt but covered with sand, gravel or other aggregates
Warning: slipping hazard!
4.2.4.1 Travelling with the platform in the transport position
Adjusting the speed:
It is possible, using selector 8 on the push-button panel, to enable the second
travel speed with the work platform in the transport position.
Tortoise: engine accelerated, each joystick controls the respective track. This
allows to have the correct power to counter-steer and climb up inclined ramps
with the platform.
Hare: engine accelerated, the left joystick is not active, the right joystick (11)
controls both tracks.
The machine can travel only in a straight line.
In this particular travel mode, the following functions are also enabled:
Capacity variation of the hydraulic engines:
The hydraulic engines use smaller capacities allowing for the speed to be
increased (but at the expense of traction)
Booster:
After a delay of 1 second from the start of the control, the hydraulic engines are
connected in series resulting in the speed doubling.
Warning: When the joystick is released, the machine will not stop immediately
bit there is a deceleration ramp. The space travelled before it stops can even be
of 40cm.